Focus L4-2.0L (2009)
VDB05 (WH), harness side and ground.
-
Is the voltage greater than 6 volts?
Yes
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The HS-CAN has tested within specifications. Go To Pinpoint Test N to test for an intermittent network fault condition. See: Pinpoint Test N:
Intermittent No High Speed Controller Area Network (HS-CAN) Communication, One Or More Modules Are Not Respond
-------------------------------------------------
O5 CHECK THE HS-CAN TERMINATION RESISTOR
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to O6.
No
GO to O9.
-------------------------------------------------
O6 CHECK THE HS-CAN TERMINATION RESISTOR WITH THE PCM DISCONNECTED
-
Disconnect: PCM C175b.
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to O7.
No
GO to O8.
-------------------------------------------------
O7 CHECK THE HS-CAN CIRCUITS BETWEEN THE PCM AND THE DLC FOR AN OPEN
