Focus L4-2.0L (2009)
Valve Clearance: Adjustments
Valve Clearance Check
1. Remove the valve cover. For additional information, refer to Valve Cover See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal
and Replacement/Valve Cover.
2. Remove the 2 bolts and accessory drive belt splash shield.
-
To install, tighten to 9 Nm (80 lb-in).
3. NOTE: Turn the engine clockwise only, and use the crankshaft bolt only.
NOTE: Measure each valve's clearance at base circle, with the lobe pointed away from the tappet, before removing the camshafts. Failure to
measure all clearances prior to removing the camshafts will necessitate repeated removal and installation and wasted labor time.
Use a feeler gauge to measure each valve's clearance and record its location.
4. NOTE: The number on the valve tappet only reflects the digits that follow the decimal. For example, a tappet with the number 0.650 has the
thickness of 3.650 mm.
NOTE: The nominal clearance is:
-
intake: 0.25 mm (0.0095 in).
-
exhaust: 0.30 mm (0.0115 in).
NOTE: The acceptable clearances after being fully installed are:
-
intake: 0.22-0.28 mm (0.008-0.011 in).
-
exhaust: 0.27-0.33 mm (0.010-0.013 in).
Select tappets using this formula: tappet thickness = measured clearance + the existing tappet thickness - nominal clearance.
Select the closest tappet size to the ideal tappet thickness available and mark the installation location.
5. If any tappets do not measure within specifications, install new tappets in these locations. For additional information, refer to Valve Train
Components - Exploded View See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
and Replacement/Valve Train Components - Exploded View and Valve Tappets See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and
Push Rods/Lifter / Lash Adjuster/Service and Repair/Removal and Replacement/Valve Tappets.
