Focus L4-2.0L (2009)
Acceleration/Deceleration Sensor: Service and Repair
Stability Control Sensor Cluster
Removal and Installation
1. Remove the RH front seat.
2. Remove the pin-type retainer and position the RH rear footwell duct aside.
3. Remove the 3 stability control sensor cluster bolts and position the sensor cluster to access the electrical connector.
-
To install, tighten to 10 Nm (89 lb-in).
4. Disconnect the electrical connector and remove the sensor cluster assembly.
5. Remove the 2 stability control sensor cluster nuts and the stability control sensor cluster.
-
To install, tighten to 8 Nm (71 lb-in).
6. To install, reverse the removal procedure.
-
Carry out the IVD Initialization sequence. Follow the scan tool directions.
