Focus L4-2.0L (2009)
Inertia Fuel Shutoff Switch: Service and Repair
Inertia Fuel Shutoff (IFS) Switch
Removal and Installation
1. Remove the 2 pin-type retainers and the RH A-pillar lower trim panel.
2. Disconnect the Inertia Fuel Shutoff (IFS) switch electrical connector.
3. NOTICE: Do not overtighten the fasteners or damage to the switch will occur.
Remove the 2 bolts and the IFS switch.
-
To install, tighten to 2 Nm (18 lb-in).
4. To install, reverse the removal procedure.
-
If necessary, reset the IFS switch after the installation has been completed.
