Focus L4-2.0L (2009)
11. Remove the nut from the pressure line bracket-to-starter stud and position the pressure line bracket aside.
-
To install, tighten to 9 Nm (80 lb-in).
12. Remove the steering line-to-steering gear retainer bolt and release the pressure line from the retainer.
13. Disconnect the pressure line from the steering gear.
-
Remove the steering line clamp plate bolt and rotate the clamp plate.
-
To install, tighten to 23 Nm (17 lb-ft).
14. Release the pressure line from the 4 pressure and return line retainers.
Vehicles with automatic transmission
15. Disconnect the selector lever cable from the transmission.
-
Pinch the selector lever cable retainer clips together and carefully pull outward to detach the cable from the cable bracket.
-
Carefully pull outward on the cable end to detach it from the shift shaft lever.
-
Position the cable and retainer away from the pressure line.
All vehicles
16. Remove the pressure line.
17. NOTE: Make sure the pressure line is routed correctly.
To install, reverse the removal procedure.
18. Fill the power steering system.