Focus L4-2.0L (2009)
Removal
1. Remove the battery.
2. Remove the 3 battery tray nuts. Pull the battery tray up, disconnect the wiring harness fasteners from the battery tray and remove the battery tray.
3. Install the Engine Support Bar and Adapters and support the engine.
4. Remove the transaxle support bolt and nuts and remove the transaxle support insulator.
Installation
1. Install the transaxle support insulator nuts.
-
Install the 4 support insulator-to-body nuts.
-
Tighten to 48 Nm (35 lb-ft).
-
Install the support insulator-to-bracket nut.
-
Tighten to 150 Nm (111 lb-ft).
