Focus L4-2.0L (2009)
Flywheel: Removal and Replacement
Flywheel
Removal
1. With vehicle in NEUTRAL, position it on a hoist.
2. Remove the manual transaxle and clutch.
3. Install the Flywheel Holding Tool and remove the 6 bolts and the flywheel.
Installation
NOTE: Engine balancing is not required. Balance weights should not be installed on the new flywheel.
NOTE: Special bolts are used for installation. Do not use standard bolts.
1. Inspect the pilot bearing. Install a new pilot bearing as necessary.
2. Install the flywheel and the 6 bolts.
3. Install the Flywheel Holding Tool.
4. NOTE: Special bolts are used for installation. Do not use standard bolts.
Tighten the bolts in the sequence shown in 3 stages.
-
Stage 1: Tighten to 50 Nm (37 lb-ft).
-
Stage 2: Tighten to 80 Nm (50 lb-ft).
-
Stage 3: Tighten to 112 Nm (83 lb-ft).
