Focus L4-2.0L (2009)
Windshield Washer Pump: Service and Repair
Washer Pump and Reservoir
Removal and Installation
1. Remove the washer fluid reservoir filler neck bolt.
2. Position aside the coolant overflow bottle.
-
Remove the 2 bolts and position the coolant overflow bottle aside.
3. With the vehicle in NEUTRAL, position it on a hoist.
4. Remove the radiator lower air deflector.
5. Disconnect the washer pump electrical connector.
6. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical
advice. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these
instructions may result in serious personal injury.
NOTICE: To prevent damage to the connector, do not use hand tools to remove/install the washer pump hose.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.
Disconnect the washer pump hose.
-
Gently twist the lock ring until the ring has rotated approximately 90 degrees.
-
The hose should slide easily out of the connection.
-
To install, make sure the hose is fully seated and locked into place.
7. NOTICE: Do not leave the lock ring in the disassembled position. This will weaken the ring and may prevent it from correctly locking in
place when reassembled, resulting in a leak.
Rotate the lock ring back to the original location.
8. Remove the windshield reservoir.
-
Remove the nut and 2 bolts.
-
To install, tighten to 5 Nm (44 lb-in).
