Focus L4-2.0L DOHC VIN 3 (2002)
12. Remove the engine lifting eye.
13. Detach the intake manifold (graphic shows engine removed).
1. Remove the intake manifold studs on the front end of the engine.
2. Remove the five bolts and two nuts.
Installation
1. Install the intake manifold (graphic shows engine removed).
NOTE: Stud tightening torque = 10 Nm.
1. Screw in the intake manifold studs.
2. Tighten the five bolts and two nuts.
2. Install the engine lifting eye.
3. Install the generator.
4. Install the fuel pressure sensor.
