Focus L4-2.0L DOHC VIN 3 (2002)
Horn Switch: Service and Repair
REMOVAL
1. Remove the driver air bag module.
2. Disconnect the left and right - hand electrical connectors from the contact plate.
^
Release the locking tang on the underside of each connector.
WARNING: THE AIR BAG MODULE SHOULD ONLY BE INVERTED LONG ENOUGH FOR THE CONTACT PLATE TO BE
REMOVED. HANDLE WITH EXTREME CARE MAKING SURE, THAT IF FOR ANY REASON THIS PROCEDURE IS STOPPED,
THE AIR BAG MODULE IS TURNED THE CORRECT WAY UP, WITH THE TRIM COVER SIDE UPPERMOST. FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY INCREASE THE POSSIBILITY OF PREMATURE AIR BAG DEPLOYMENT AND MAY
CAUSE PERSONAL INJURY.
3. Remove the contact plate.
1. Remove each of the four wedges.
NOTE: The contact plate holds four horn contact plate springs in position. Before the contact plate is removed note there position and seating
arrangement.
2. Remove the contact plate.
INSTALLATION
