Focus L4-2.0L DOHC VIN 3 (2002)
-
Discard the snap ring.
-
Allow the oil to drain into a suitable container.
7. Using the special tools, remove the halfshaft oil seal.
Installation
1. Using the special tools install the halfshaft oil seal.
2. CAUTION: Support the halfshaft. The inner joint must not be bent more than 18 degrees. The outer joint must not be bent more than 45 degrees.
CAUTION: Do not damage the halfshaft oil seal.
CAUTION: Make sure the snap ring is correctly seated.
NOTE: Install a new snap ring.
Attach the halfshaft to the transaxle
3. CAUTION: The lower arm pinch bolt must be installed from the rear of the wheel knuckle.
