Focus L4-2.0L DOHC VIN 5 (2003)
Impact Sensor: Procedures
REMOVAL
WARNING:
^
TO AVOID ACCIDENTAL DEPLOYMENT, THE AIR BAG CONTROL MODULE BACKUP POWER SUPPLY MUST BE
DEPLETED. WAIT AT LEAST ONE MINUTE AFTER DISCONNECTING THE BATTERY GROUND CABLE(S) BEFORE
COMMENCING ANY REPAIR OR ADJUSTMENT TO THE SUPPLEMENT RESTRAINT SYSTEM (SRS), OR ANY
COMPONENT(S) ADJACENT TO THE SRS SENSORS. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN
PERSONAL INJURY.
^
TO MINIMIZE THE POSSIBILITY OF PREMATURE DEPLOYMENT, DO NOT USE RADIO KEY CODE SAVERS WHEN
WORKING ON THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN
PERSONAL INJURY.
^
NEVER PROBE THE ELECTRICAL CONNECTORS OF AIR BAG MODULES OR ANY OTHER SUPPLEMENTAL RESTRAINT
SYSTEM COMPONENT. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN PERSONAL INJURY.
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove the radiator right-hand support bracket retaining bolts and lower the right-hand side of the radiator.
4. Lower the vehicle.
5. Remove the radiator air deflector.
6. Detach the crash sensor from the radiator grille opening panel.
