Focus L4-2.0L DOHC VIN 5 (2003)
Impact Sensor: Removal and Replacement
Side Impact Sensor
Removal
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not
indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the system. For additional information, See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair
2. Remove the front seat.
3. Remove the front and rear scuff plates.
4. Detach the floor covering from the floor panel.
5. Disconnect the side impact sensor electrical connector.
6. Remove the side impact sensor.
