Focus L4-2.0L DOHC VIN 5 (2003)
Alignment: Service and Repair
Suspension Design Height Setting
Suspension Design Height Setting
All vehicles
1. NOTE: The final tightening of the suspension must be carried out at the design height setting.
Remove the springs.
3-door, 4-door and 5-door
2. Detach the stabilizer bar from the rear lower arm.
3. Fabricate a 20 mm wide by 113 mm long spacer.
4. Using a suitable wooden block and a suitable transmission jack, raise the suspension to the design height setting.
^
Position the wooden block and transmission jack as shown.
