Focus L4-2.0L DOHC VIN 5 (2003)
7. Remove the halfshaft seal.
Installation
1. Using the special tools, install the halfshaft seal.
2. CAUTION: Support the halfshaft. The inner joint must not be bent more than 18 degrees. The outer joint must not be bent more than 45 degrees.
CAUTION: Do not damage the halfshaft seal.
CAUTION: Make sure the snap ring is correctly seated.
Attach the halfshaft to the transaxle.
3. Attach the lower arm to the wheel knuckle.
4. WARNING: Install a new tie-rod end retaining nut. Failure to follow this instruction may result in personal injury.
Attach the tie-rod end to the wheel knuckle.