Focus L4-2.0L DOHC VIN 5 (2003)
3. CAUTION: Make sure the cutting blades are changed where the cutting depth changes to avoid damage to the body and trim panels.
NOTE:
-
Some resistances may be encountered when cutting through the glass locating pegs in the upper right and lower left corners of the glass.
-
Lubricate the existing urethane adhesive with water to aid the special tool while cutting.
Using the special tool, place the flat side of the knife against the quarter glass window. Start at the top and work towards the corners cutting to the
given maximum depths.
1
20 mm.
2
30 mm.
3
50 mm.
4
40 mm.
4-Door
4. CAUTION: Make sure the cutting blades are changed where the cutting depth changes to avoid damage to the body and trim panels.
NOTE:
-
Some resistances may be encountered when cutting through the glass locating pegs in the upper right and lower left corners of the glass.
-
Lubricate the existing urethane adhesive with water to aid the special tool while cutting.
Using the special tool, place the flat side of the knife against the quarter glass window. Start at the top and work towards the corners cutting to the
given maximum depths.
1
20 mm.
2
25 mm.
3
45 mm.
4
50 mm.
5
55 mm.
6
7O mm.
7
150 mm.
All vehicles
5. Remove the rear quarter window glass.
6. Using a soft brush or vacuum, remove any dirt or foreign material from the pinch weld.
INSTALLATION
CAUTION: When installing urethane installed glass parts, the vehicle must not be driven until the urethane adhesive has cured. At
temperatures above 21°C (70°F) and relative humidities above 50%, adequate cure time is typically 24 hours. (Refer to Essex drive away chart
for the cure times as temperatures and humidity vary.) Inadequate or incorrect curing can adversely affect the retention of the quarter window
