Focus L4-2.0L SOHC VIN P (2000)
Seat Cushion: Service and Repair
Removal And Installation
REMOVAL
1. Disconnect the battery ground cable.
^
Wait one minute.
WARNING: WAIT AT LEAST ONE MINUTE AFTER DISCONNECTING THE BATTERY GROUND CABLE BEFORE
DISCONNECTING ANY SUPPLEMENTAL RESTRAINT SYSTEM ELECTRICAL CONNECTORS. FAILURE TO FOLLOW THIS
WARNING COULD CAUSE PREMATURE AIR BAG DEPLOYMENT AND MAY RESULT IN PERSONAL INJURY.
2. Remove the seat. For additional information, refer to Front Seat.
3. Detach the pyrotechnic pretensioner wiring harness from the underside of the cushion.
CAUTION: Note the position and routing of the wiring harness(es) to aid assembly. An incorrectly routed wiring harness may lead to the wires
becoming damaged on the seat mechanism.
4. Remove the seat cushion.
^
Remove the bolts.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: Make sure the seat wiring harness is correctly routed to prevent the harness becoming trapped.
