Focus L4-2.0L SOHC VIN P (2000)
Brake Master Cylinder: Service and Repair
Removal and Installation
Removal
All Vehicles
1. CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. Disconnect the battery
ground cable.
2. Disconnect the electrical connector from the filler cap.
1
Pull back the tab.
2
Depress the clips.
3
Disconnect the electrical connector.
3. CAUTION: Make sure the filler cap does not become contaminated. Remove the brake fluid reservoir filler cap.
4. Loosen the wheel nuts of both front wheels.
5. Raise and support the vehicle.
6. Remove the front wheels.
7. Loosen the bleed nipple.
1
Remove the dust cap.
2
Loosen the bleed nipple.
