Focus L4-2.0L SOHC VIN P (2000)
2.
Remove the speed control cable from the pulley by pushing the cable out of the pulley. See Figure 6.
3.
Insert the new cable end into the pulley and pull the cable to lock it into position.
4.
Align the cable cover tabs with the slots in the servo housing. Insert the cover into the servo, then push down and rotate clockwise until the locking
arm engages.
SPEED CONTROL SERVO INSTALLATION
1.
Install the speed control servo in the vehicle. Tighten the nuts 20 Nm (15 lb-ft).
2.
Install the brake master cylinder reservoir. Tighten the retaining screws to 4 Nm (35 lb-in).
3.
Connect the brake master cylinder reservoir electrical connector.
4.
Connect the electrical connector to the servo.
5.
Connect the canister purge outlet tube.
6.
Attach the speed control cable to the throttle body bracket and connect the speed control cable to the throttle body.
7.
Install the air cleaner outlet tube.
