Focus L4-2.0L SOHC VIN P (2000)
6.
Install fuel pressure gauge special service tool 310-012 or equivalent.
7.
Install fuel pump relay.
8.
Cycle key and wait 3 seconds to re-pressurize the fuel system. Check for oaks before starting engine.
NOTE
IT MAY TAKE MORE THAN ONE KEY CYCLE TO RE-PRESSURIZE THE FUEL SYSTEM.
9.
Start and run engine to surge air from fuel system (air trapped in the fuel system may effect test results).
10.
Perform normal diagnosti35 ann service repairs as needed.
11.
After fuel system service is complete, relieve fuel system pressure using fuel pressure gauge relief valve.
12.
Remove special service tools
13.
Re-connect fuel system lines
14.
Cycle key and wait 3 seconds to re-pressurize the fuel system. Check for leaks before starting engine.
NOTE
IT MAY TAKE MORE THAN ONE KEY CYCLE TO RE-PRESSURIZE THE FUEL SYSTEM.
15.
Start vehicle and check for leaks.
NOTE
IT IS POSSIBLE THAT A DTC MAY BE SET DUE TO THE PUMP RELAY BEING PULLED AND THE ENGINE STARTED AND RUN OUT
OF FUEL. IF DTC'S ARE SET, CLEAR ALL DTC'S BEFORE RETURNING VEHICLE TO THE CUSTOMER.
Service Tools Required Chart
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 404000, 490000, 497000, 499000, 603300, 607000, 698298
Disclaimer
