Focus L4-2.0L SOHC VIN P (2000)
INSTALLATION
1. Fit the compressor magnetic coil assembly (FS10 compressor shown).
-
Pull on the compressor magnetic coil assembly as far as the stop using a bolt (M6x30) with washer, a suitable thrust washer and the drive plate.
1. M6x3O bolt with washer
2. Drive plate
3. Thrust washer
4. Magnetic coil assembly
NOTE:
-
Do not skew the magnetic coil assembly of the compressor when fitting it to the compressor seating.
-
Remove the bolt, drive plate and thrust washer after fitting the magnetic coil assembly.
2. Attach the compressor pulley.
-
Install the pulley snap-ring.
NOTE: Install a new pulley snap-ring.
