Focus L4-2.0L SOHC VIN P (2000)
1.
Using a high pressure water hose or a pressure washer, run water onto the windshield being sure to direct water over the roof ditch moldings, and
down onto the cowl (Figure 1).
2.
Open the hood and direct water (from the side of the vehicle) into the base of the A-pillar in the hood hinge area (Figure 2).
3.
Remove right front inner splash shield and direct water into the back of the right front wheel well area (Figure 3). Refer to Workshop Manual,
Section 501-02.
4.
Proceed to Water Leak Inspection/Repair Procedure.
Water leak Inspection/Repair Procedure
Inspect the following areas for visible signs of leaks and follow the appropriate repair steps.
Water is visible at Blower Motor Connector, Blower Motor Resistor, Blower Motor Mounting Flange, or Foot Air Duct:
