Focus L4-2.0L SOHC VIN P (2000)
Fuel Filler Hose: Service and Repair
REMOVAL
WARNING: DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR
ANY FUEL RELATED COMPONENTS. HIGHLY FLAMMABLE VAPORS ARE ALWAYS PRESENT AND MAY IGNITE. FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
1. Disconnect the battery ground cable.
2. Loosen the right-hand rear wheel nuts.
3. Remove the fuel filler cap.
4. Raise and support the vehicle. For additional information, refer to Maintenance/Service and Repair.
5. Remove the right-hand rear wheel.
6. Remove the right-hand rear splash shield.
7. Disconnect the fuel tank vent pipes and filler pipe.
CAUTION: When removing the fuel tank vent and filler pipe, do not use any sharp edge tools to lever off the pipes. Failure to follow this
instruction may result in damage to the filler pipes.
NOTE: Make a note of the position of the retaining clamp and clip to make sure that it is positioned in exactly the same position when installed.
8. Disconnect the canister vent solenoid tube.
CAUTION: Care must be taken to avoid damaging the canister vent solenoid.
