Focus L4-2.0L SOHC VIN P (2000)
Power Door Lock Switch: Testing and Inspection
Component Testing Instructions
Component testing procedures are provided to determine whether a component is good or bad.
Testing information for each component includes a schematic with component terminal locations and step-by-step test procedures. Component terminals
are identified by letters or numbers that may be marked on the component or callout if there is no mark on the component.
The component connector MUST BE REMOVED before testing. To test a single circuit within the component, select that circuit under the column TO
TEST If you wish to test the complete component, perform all tests.
Connect the tester to the terminals shown in the second column and operate the component as shown in the third column.
