Focus L4-2.0L SOHC VIN P (2000)
7.
Remove the smaller red auxiliary power harness from the battery tray and then remove the offset anchoring clip from the harness. Do not discard
the clip at this time.
8.
Install one of the two (2) supplied push pins (Item No. 9) into the auxiliary power harness anchor location.
9.
Install the large diameter 229 mm (9 in) convolute tube (Item No. 2) over the auxiliary power harness and secure in place with black vinyl tape
using a "candy stripe" pattern. See Figure 4.
10.
NOTE: When marking the battery tray, be sure to allow for slack in the auxiliary wire harness behind the battery tray.
