Focus L4-2.0L SOHC VIN P (2000)
11.
Using the remaining new anchoring tie straps (Item No. 8), secure the positive cable to the outer right side of the battery tray. Route the positive
cable over the auxiliary power harness as shown in Figure 18.
12.
Connect the battery positive cable and then connect the auxiliary power harness to the battery positive cable. Route the battery positive cable over
the auxiliary power harness. Tighten the fasteners as follows:
a)
Battery positive cable to 8 Nm (71 lb-in)
b)
Auxiliary power harness to 5 Nm (44 lb-in)
13.
Connect the battery negative cable and then connect the auxiliary ground wire to the battery negative cable. Tighten the fasteners as follows:
a)
Battery negative cable to 8 Nm (71 lb-in)
b)
Auxiliary ground wire to 5 Nm (44 lb-in)
14.
Connect the body ground cable.
15.
Install the air cleaner assembly as follows:
a)
Position the air cleaner assembly into the vehicle.
b)
Tighten the air cleaner tube at the throttle body.
c)
Connect the PCV tube.
d)
Connect the MAP sensor electrical connector.
16.
Install the battery cover, close the hood and release the vehicle.
