Focus L4-2.0L SOHC VIN P (2000)
Place the clip removed in Step 7 against the inner right side of the battery tray. With the rear edge of the clip at least 6 mm (1/4 in) away from the
rear of the battery tray and with at least 6 mm (1/4 in) of clearance between the clip and the top edge of the battery tray, mark the location of the
push pin as shown in Figure 5.
11.
Using a 6 mm (1/4 in) drill bit, drill a hole into the battery tray at the marked location.
12.
Install the clip removed in Step 7 into the drilled hole.
13.
Position the auxiliary power harness onto the installed clip, but do not attach the harness to it. Once the harness is positioned in such a manner as
to allow for some slack behind the battery tray, mark the clip's position on the harness.
14.
Install the new offset anchoring clip (Item No. 4) onto the marked location of the harness and secure it in place with black vinyl tape.
15.
Remove and discard the original clip from the battery tray and then install the auxiliary power harness into its new position on the battery tray.
