Focus L4-2.0L SOHC VIN P (2000)
1. CAUTION: The stabilizer bar bushings must be located correctly on the flats of the stabilizer bar with no lubricant.
Install the bushings onto the stabilizer bar (both sides).
2. Set the stabilizer bar to the design height setting.
1. Locate the bushing against the spacer (both sides).
2. Support the stabilizer bar to specification (both sides).
3. Install the clamps.
1. Apply water to the clamp to assist installation.
2. Press the clamp onto the bushing.
4. Install the clamp rear bolts (both sides).
5. Install the clamp front bolts (both sides).