Focus L4-2.0L SOHC VIN P (2000)
7.
Connect the parking brake cable to the caliper, then install the bolt securing the cable to the rear knuckle assembly.
8.
Beginning with Step 2 of Wheel Hub Removal - All Vehicles and ending with Step 7 of Wheel Hub Installation - All Vehicles, repeat all necessary
service procedures in this document for the other rear wheel hub assembly. Once the other rear wheel hub assembly has been serviced, proceed to
Step 9 of Wheel Hub Installation - All Vehicles.
9.
Install the rear wheels. Tighten lug nuts to 128 Nm (94 lb-ft).
10.
If tension on the parking brake was released for wheel hub removal, the parking brake must be adjusted. Refer to Section 206-05 in the 2001
Focus Workshop Manual.
