Focus L4-2.0L SOHC VIN P (2000)
1. Using the special tool, install the differential seal(s).
2. CAUTION: The inner joint must not be bent at more than 18 degrees; the outer joint must not be bent at more than 45 degrees.
NOTE: Install new nuts and a new center bearing cap.
Install the right-hand front drive halfshaft together with the intermediate shaft.
3. CAUTION: The inner joint must not be bent at more than 18 degrees; the outer joint must not be bent at more than 45 degrees.
NOTE: Install the new snap ring.
Install the left-hand front drive halfshaft (subframe removed shown).
4. Install both suspension arms (left-hand side shown).
