Focus L4-2.0L SOHC VIN P (2000)
Using the special tool install the clamping strops in the boot ring grooves.
3. Install gaiter at the transaxle end.
-
Insert the clamping strap in the boot ring groove and tighten it using the special tool.
4. CAUTION: Do not damage the universal joint rollers.
Install the tripod.
-
Using the special fool, push the tripod onto the front drive halfshaft as far as it will go.
5. NOTE: Install a new snap ring.
Install the tripod (continued).
-
Install the snap ring.
6. NOTE: To determine the amount of grease, refer to Specifications for fill capacities.
Inject half of the specified amount of grease into the transaxle side end of the tripod joint. Inject the other half amount of grease into the boot.
