Focus L4-2.0L SOHC VIN P (2000)
2. Loosen the hub nuts.
1. Wheel nuts
2. Hub nut*
3. Raise and support the vehicle.
4. Remove the right-hand wheel.
5. CAUTION: Protect the ball point seal using a soft cloth to prevent damage.
Detach the right-hand lower arm.
1. Remove the bolt.
2. Detach the lower arm ball joint.
6. CAUTION: The hub nut can be re-used four times; mark the nut.
Detach the right-hand drive halfshaft from the wheel hub.
^
Unscrew and remove the hub nut and press out the hub from the wheel hub using a commercially available puller.
CAUTION: To avoid damage to the halfshaft joint and boot, the inner halfshaft joint must not be bent by more than 18 degrees.
7. NOTE: Allow the oil to drain into a suitable container.
