Focus L4-2.0L SOHC VIN P (2000)
Using the supplied 320 grit emery cloth, remove any corrosion that may exist in the wheel bearing area of the wheel hub assembly. See Figure 3.
5.
CAUTION: When installing the new wheel bearing into the hub assembly, be sure to apply force only to the outer race of the bearing.
NOTE:
When installing the new wheel bearing into the hub assembly, the black rubber seal faces up.
Using a suitable drift and press, press the new wheel bearing into the hub assembly. See Figure 4.
6.
Install the circlip into the hub assembly.
7.
Using Rotunda Tool Handle 205-153 combined with either Rotunda Water Seal Carrier Installer 204-322 for drum brakes or 204-323 for disc
brakes, install the water seal carrier into the hub assembly. See Figure 5.
8.
CAUTION: The water seal carrier will protrude above the ABS tone ring when both are correctly installed. Use caution when installing the ABS
tone ring to avoid damaging the carrier.
CAUTION:
Use of a steel installation device may damage or affect the magnetic properties of the tone ring. Use only a non4errous device to install the
