Focus L4-2.0L SOHC VIN P (2000)
5. Remove the polyurethane (PU) adhesive cap and heat the PU adhesive for a minimum of 30 minutes.
6. Disconnect the heated rear window electrical connectors.
7. WARNING: Wear gloves and eye protection when working with the glass cutting tool as the cutting operation may produce splinters.
When using the cutter wear ear protectors. Failure to follow these instructions may result in personal injury.
CAUTION: Make sure the cutting blades are changed where the cutting depth changes to avoid damage to the body and trim panels.
NOTE: Some resistance may be encountered when cutting through the glass locating pegs in the lower corners of the glass.
From inside the vehicle using a suitable direct glazing cutter, cut the PU adhesive to the given maximum depths.
1. 25mm
2. 65 mm
3. 80mm