Focus L4-2.0L SOHC VIN P (2000)
Quarter Window Glass: Service and Repair
4-Door
REMOVAL
1. Heat the Polyurethane (PU) adhesive if necessary.
NOTE: Should the ambient temperature fall below 10°C, heat the cartridges for approximately 15 minutes by placing them on a warm radiator,
or by using a hot air gun set at approximately 25°C.
2. Remove the C-pillar trim panel.
3. Detach the door weatherstrip.
4. From inside the vehicle cut the PU adhesive at the given maximum depths. Use the recommended blades, following the proprietary tool
manufacturers instructions.
1. 20 mm.
2. 25 mm.
3. 45 mm.
4. 50 mm.
5. 55 mm.
6. 70 mm.
7. 150 mm.
WARNING: WEAR GLOVES AND EYE PROTECTION WHEN WORKING WITH THE GLASS CUTTING TOOL AS THE
CUTTING OPERATION MAY PRODUCE SPLINTERS. WHEN USING THE CUTTER WEAR EAR PROTECTORS. FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
