Focus L4-2.0L VIN N (2006)
Antenna Cable: Service and Repair
ANTENNA CABLE
Removal and Installation
CAUTION: The antenna lead-in cable is not removable from the wiring harness. If a new lead-in cable is being installed, leave it in the wiring
harness. Install a new cable on top of the instrument panel wiring harness and secure it with wire ties. Do not cut into the wiring harness to
remove the existing antenna lead-in cable. Tie back or insulate the old cable ends to keep them from causing noise.
1. Remove the antenna base.
2. Remove both A-pillar trim panels.
3. NOTE: LH shown, RH similar.
Remove the 4 screws and the sun visors.