Focus L4-2.0L VIN N (2006)
3.
Remove right front inner splash shield and direct water into the back of the right front wheel well area. (Figure 3) Refer to Workshop Manual
(WSM), Section 501-02.
4.
Proceed to Water Leak Inspection/Repair Procedure.
Water leak Inspection/Repair Procedure
Inspect the following areas for visible signs of leaks and follow the appropriate repair steps.
Water is Visible in the Right or Left Kick Panel/A-Post Area
NOTE
IT MAY BE NECESSARY TO REMOVE THE HOOD, HOOD HINGES AND/OR COWL PANEL TRIM TO FULLY ACCESS AND REPAIR
SOME LEAK SOURCES. FOLLOW WSM, SECTION 501-02 IF HOOD, HOOD HINGES AND/OR COWL PANEL TRIM REMOVAL IS
NECESSARY.
1.
Inspect for sealer skip behind roof ditch moldings. Fold the ditch molding back and inspect for a pinhole in the body seal just above the
windshield. Reseal as necessary with Motorcraft Roof Ditch Sealer. (Figure 4)
2.
Inspect for skip in windshield urethane. Reseal as necessary.
