Focus L4-2.0L VIN N (2006)
Oil Filter Adapter: Service and Repair
Oil Filter Adapter
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the oil pressure sender electrical connector.
3. Remove the oil filter.
4. Remove the 4 bolts and the oil filter adapter.
^
Discard the gasket.
^
To install, tighten to 25 Nm (18 ft. lbs.).
5. To install, reverse the removal procedure.
^
Install a new oil filter adapter gasket.
6. Top off the engine with clean engine oil.
