Removal and Installation Removal Vehicles with rear disc brakes Vehicles with rear drum brakes | -
NOTE:If the dust cap is damaged on removal a new dust cap must be used on installation. Remove the dust cap. | | -
Release the parking brake. | | -
Remove the brake drum. - Remove the hub retaining nut.
- Remove the brake drum.
| All vehicles | -
Remove the wheel speed sensor ring (drum brake shown, disc brake similar). - Discard the wheel speed sensor ring.
| Installation All vehicles | -
CAUTION:Make sure the wheel speed sensor ring is not knocked, damaged and keep free from metal fragments. CAUTION:Protect the face of the wheel speed sensor ring with a suitable non-ferrous flat block to prevent damage. CAUTION:Make sure the brake drum is adequately supported and do not allow it to rest on the wheel studs. CAUTION:Make sure the wheel speed sensor ring is pressed on slowly and squarely until fully seated. CAUTION:Do not exceed a maximum load of 10 kn. Using a suitable hydraulic press install a new wheel speed sensor ring. | Vehicles with rear disc brakes Vehicles with rear drum brakes | -
CAUTION:Rotate the drum in the opposite direction when tightening the hub nut to prevent damage to the bearing. Install the brake drum. | |