| General Procedures | | -
Frame dimensions - 3/5-door versions - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions were measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
| | | -
Frame dimensions - 3/5-door versions - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions were measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
| | | -
Frame dimensions - 4-door version - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions were measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
| | | -
Frame dimensions - 4-door version - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions were measured from the centre of the hole with a symmetrically adjusted beam trammel and with the component assemblies removed.
| | | -
Frame dimensions - estate version - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions were measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
| | | -
Frame dimensions - estate version - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions were measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
| | |
