Focus ZTS L4-2.0L DOHC VIN 3 (2001)
Brake Caliper: Service and Repair
Caliper Removal and Installation
Brake Caliper
Removal
CAUTION: If brake fluid is spilt on the paint-work, the affected area must be immediately washed down with cold water.
1. Loosen the wheel nuts.
2. Raise and support the vehicle.
3. Remove the wheel.
4. Detach the brake hose from the support bracket.
5. Loosen the brake hose.
6. Remove the front brake pads.
7. CAUTION: Cap the brake hose to prevent fluid loss and dirt contamination.
Disconnect the caliper from the brake hose.
Installation
1. NOTE: After installation, bleed the brake system.
