Focus ZTS L4-2.0L DOHC VIN 3 (2001)
Leak Detection Valve: Service and Repair
REMOVAL
1. Remove the Evaporative Emission (EVAP) canister.
2. Remove the canister vent solenoid.
INSTALLATION
1. To install, reverse the removal procedure.
^
Carry out the Leak Test. See: Testing and Inspection/Component Tests and General Diagnostics/Evaporative Emission System Leak Test
^
Carry out the Evaporative Emission Repair Verification Drive Cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Evaporative Emission Repair Verification Drive Cycle
NOTE:
^
Lubricate the O-ring with Merpol O-ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144B.
^
A canister and bracket assembly leak test should be carried out before installation on the vehicle.
