Focus ZTS L4-2.0L DOHC VIN 3 (2001)
2. Remove the upper screw.
3. Detach the front clips.
4. Detach the upper clips.
NOTE: The screws are located behind the backrest and beneath the seat cushion.
6. Detach the waist guide loop.
1. Slide the waist guide loop backwards.
2. Slide the waist guide loop down.
3. Detach the waist guide loop.
7. Disconnect the safety belt retractor pretensioner electrical connector.
8. Remove the safety belt retractor.
1. Remove the bolt.
2. Lift the retractor from its locating tang.
INSTALLATION
WARNING:
^
ALWAYS WEAR SAFETY GLASSES WHEN WORKING ON AN AIR BAG EQUIPPED VEHICLE AND WHEN HANDLING THE
AIR BAG MODULE. FAILURE TO FOLLOW THIS WARNING COULD CAUSE PREMATURE DEPLOYMENT AND MAY
RESULT IN PERSONAL INJURY.
^
REPAIR IS MADE BY INSTALLING A NEW COMPONENT ONLY. DO NOT INSTALL NEW COMPONENTS UNLESS THE
ORIGINAL COMPONENT IS DAMAGED OR FOUND TO BE FAULTY AFTER THE COMPLETION OF THE CORRECT
DIAGNOSTIC PROCEDURES. FAILURE TO FOLLOW THIS WARNING COULD CAUSE PREMATURE DEPLOYMENT AND
MAY RESULT IN PERSONAL INJURY.
^
NEVER PROBE THE ELECTRICAL CONNECTORS OF AIR BAG MODULES OR ANY OTHER SUPPLEMENTAL RESTRAINT
SYSTEM ELECTRICAL CONNECTORS. FAILURE TO FOLLOW THIS WARNING COULD CAUSE PREMATURE
DEPLOYMENT AND MAY
