Focus ZTS L4-2.0L DOHC VIN 3 (2001)
1. To install, reverse the removal procedure.
CAUTION:
^
Make sure the spacer is correctly located between the floor covering and inner sill.
^
Make sure the pin on the B-pillar trim is located correctly into the height adjuster.
^
Make sure that the rear end of the anchor rail, on 3-door vehicles, is correctly located before tightening the Torx bolt.
3 Door
REMOVAL
1. Detach the safety belt lower anchor.
1. Remove the Torx bolt from the anchor rail.
2. Slide the safety belt off the anchor rail.
