Focus ZTS L4-2.0L DOHC VIN 3 (2001)
6. Remove and discard the O-ring seal.
INSTALLATION
WARNING:
^
DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY
FUEL RELATED COMPONENTS. HIGHLY FLAMMABLE VAPORS ARE ALWAYS PRESENT AND MAY IGNITE. FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
^
THIS PROCEDURE INVOLVES FUEL HANDLING. BE PREPARED FOR FUEL SPILLAGE AT ALL TIMES AND ALWAYS
OBSERVE FUEL HANDLING PROCEDURES. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL
INJURY.
^
THE FUEL SYSTEM REMAINS PRESSURIZED FOR A LONG TIME AFTER THE IGNITION IS SWITCHED OFF. THE FUEL
PRESSURE MUST BE RELEASED BEFORE ATTEMPTING ANY REPAIRS. FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY RESULT IN PERSONAL INJURY.
1. To install, reverse the removal procedure.
^
Lubricate the fuel pressure sensor O-ring seal with clean engine oil to aid installation.
NOTE: Install a new fuel pressure sensor O-ring seal.
