Focus ZTS L4-2.0L DOHC VIN 3 (2001)
Install the steering wheel rotation sensor clamp.
1. Install the screws.
2. Apply grease to Ford specification, to the steering column splines.
4. NOTE: Make sure the steering column shafts are aligned correctly.
Connect the steering column two halves.
5. WARNING: Make sure the breakaway capsules are located in the holes in the bracket. Failure to follow this instruction may result in
personal injury.
WARNING: Make sure the bolt is not over tightened. Failure to follow this instruction may result in personal injury.
Install the steering column bolt.
1. Align the breakaway capsules
2. Tighten the steering column bolt.
6. WARNING: Make sure the steering wheel rotation sensor locking pin is removed. Failure to follow this instruction may result in Personal
injury.