Focus ZTS L4-2.0L DOHC VIN 3 (2001)
Install the tripod.
^
Install the snap ring.
6. NOTE: To determine the amount of grease, refer to Specifications for fill capacities.
Inject half of the specified amount of grease into the transaxle side of the tripod joint. Inject the other half amount of grease into the boot.
7. Install the driveshaft at the transaxle end.
1. Insert a suitable tool under the boot seat to allow the air to escape.
2. Slide the tripod joint in as far as the stop, then pull it out 20 mm.
^
Remove the suitable tool.
8. Insert the clamping strap in the boot ring groove and tighten with the special tool.
RH
Halfshaft RH
