Focus ZTS L4-2.0L DOHC VIN 3 (2001)
CAUTION: To make sure that the PU adhesive cures, it is essential that all bonding surfaces are free of moisture.
4. Prepare the glass, rear window opening flange and trimmed PU adhesive in accordance with the instructions supplied with the adhesive kit.
5. Apply a thin continuous bead of PU adhesive to the edge of the rear window glass.
NOTE:
^
Discard the first 100 mm of PU adhesive as this may have a reduced working time.
^
To avoid water leaks, any breakage in the continuous bead should be overlapped by 20 mm.
6. Install the rear window glass weatherstrip.
7. Apply the PU adhesive in a continuous bead of between 11 and 15 mm height to the rear window flange along the bond line.
NOTE:
^
Discard the first 100 mm of PU adhesive as this may have a reduced working time.
^
To avoid water leaks, any breakage in the continuous bead should be overlapped by 20 mm.
8. With the aid of another technician, use suction cups to install the rear window glass.
NOTE: Firmly and evenly press in position; tape the glass in the correct position until the PU adhesive has cured.
9. Should the ambient temperature fall below 10°C, use a hot air gun at a distance of approximately 50 mm from the surface and apply warm air (25°
C) continuously for 15 minutes (inside or outside the vehicle).
