Focus ZTS L4-2.0L DOHC VIN 3 (2001)
NOTE:
^
Discard the first 100 mm of PU adhesive as this may have a reduced working time.
^
to avoid water leaks, any breakage in the continuous bead should be overlapped by 20 mm.
6. Install the rear quarter window glass.
NOTE: Firmly and evenly press in position; tape the glass in the correct position until the PU adhesive has cured.
7. Should the ambient temperature fall below 10°C, use a hot air gun at a distance of approximately 50 mm from the surface and apply warm air (25°
C) continuously for 15 minutes (inside or outside the vehicle).
8. Install the door weatherstrip.
9. Install the C-pillar trim panel.
