Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
5.
Remove arm rest storage compartment inner housing to reveal pivot pin (Figure 3).
6.
Remove pin, using a small hammer and drift, by tapping from drivers side and removing from passenger side.
TIP: Rotation of pin, arm rest bracket and housing, for alignment purposes, may be required to allow pin removal.
7.
Using Hinge Pin Kit, install pin through bracket and housing.
8.
Using a suitable c-clamp (Figure 4) compress arm rest bracket to allow end of pin to protrude through bracket and install cap nut.
9.
Drive cap nut onto pin using a suitable driver.
CAUTION
WHEN INSTALLING NUT, DO NOT ALLOW IMPACT TO END OF PIVOT PIN OR DAMAGE MAY OCCUR RESULTING IN
INSUFFICIENT NUT RETENTION.
10.
Reinstall arm rest storage compartment inner housing and screws. Tighten to 18 lb-in (2 N.m)
11.
Reinstall arm rest cover with the three (3) attaching screws. Tighten to 18 lb-in (2 N.m).
12.
Reinstall arm rest pivot covers.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
070604A
2000-2007 Focus: Replace
0.5 Hr.
The Center Console
Armrest Pivot Pin And Cap
Nut
DEALER CODING
